|
SIM / KS 94 and SIM / KS 98
Loop simulation with SIM / KS 98
回路仿真
To simulate a control loop, the Simulation Tool SIM
/ KS 98 uses the data of the first controller block in the engineering. If the
engineering contains several blocks of the type "CONTR" or
"CONTR+", the block with the lowest number is used. Depending on the
hardware version and the configuration, the wiring must be implemented exactly
as described in the "Help" file under "Loop simulation". At
the end of the relevant page, you will find a table that describes the wiring.
 
Copyright ©
2003 PMA Prozeß- und Maschinen- Automation GmbH
|
